The PolyVee tensioning device enables easy tensioning of 2-rib and 3-rib PolyVee belts and is intended for roller pitches 75 mm and 100 mm....
The PolyVee finger guard safely protects against inadvertently reaching between PolyVee belt and roller drive head.
The fastening socket is used for tightening according to the torque of the RollerDrive fastening nut using a torque wrench. The socket...
The RollerDrive EC310 has a glued-on ribbed nut that is located at the bearing housing. An additional nut is used to screw the RollerDrive...
The flat cable is used for the voltage supply of ConveyorControl and MultiControl. The outer contour of the line corresponds to the standard...
The flat cable is used for the communication of the ConveyorControl control system. The different controls of the system simply contact the...
The prefabricated PROFINET cable is used for communication with MultiControl. The cable allows connecting one MultiControl with another...
The Y-cable with M8 plugs enables the use of an additional input or output at the MultiControl.
The cable distribution allows splitting a flat cable. MultiControl in its initial design (article number S-1101834) allowed connecting a...
To reduce the risk of interference effects on the communication line of MultiControl, the shield of the cable can be grounded. Both sides of...
The MultiControl features 4 RollerDrive, 2 communication and 4 sensor or I/O connections. If all connections are occupied, then the...
The cable bridge allows electrically combining two flat cables and changing the position of one flat cable. The ends of both flat cables...
The small termination box serves as terminating resistor for the communication cable of the ConveyorControl system. The termination box can...
The AdControl can be used if a RollerDrive EC300 (predecessor of EC310) is to be replaced with a RollerDrive EC310. The AdControl has a...
The magnetic key with a high-quality neodyme magnet offers many functions. For the MultiControl, it enables switching the bus protocol or...
